AA Polaris Xpedition Launch Control Module

The Aftermarket Assassins Launch Control Module holds a set RPM at the line on 2024 and newer Polaris Xpedition models. With the AA turbo kit it builds boost. On the Xpedition, AA is upfront that it is mostly for fun and pops and bangs.

Why it holds up

• Developed with DynoJet, with AA wiring, switch, programming and calibration
• Programmed for a 2000 RPM launch, right at or slightly above clutch engagement
• Launch RPM is programmed by AA and can be changed with a Windows computer and DynoJet C3 software

Fits

• 2024 and newer Polaris Xpedition, 2 and 5 seat

In the box

• DynoJet launch control module, programmed by AA for 2000 RPM
• AA wiring harness with launch switch
• USB cable for adjusting launch RPM

Good to know

• Built mainly for the AA turbo kit and also works on any Xpedition running an AA tune.
• AA suggests an aftermarket exhaust such as the AA Dual Suppressor.
• For fun riding, set launch at engagement RPM to protect the clutch and belt. For drag racing, AA suggests 200 to 500 RPM above engagement. That takes more brake and builds more boost, and it is harder on the belt and clutches, so use it in moderation.
• To launch: start the machine and let it idle (the module will not engage above 1500 RPM). Press and hold the launch switch and go full throttle. The machine holds launch RPM. Most riders hold the brake too. Drop the brake and the switch at the same time to go.
• To change launch RPM: install the DynoJet C3 software on a Windows computer, connect the module with the supplied USB cable, open Configure, then Feature Enables and Inputs Selections, then Launch Control. Change the target RPM and click Send.