• DynoJet LCM launch control module with AA wiring harness and red launch button
1 1

Aftermarket Assassins

AA RZR Pro R 4 Cylinder Launch Control Module

AA RZR Pro R 4 Cylinder Launch Control Module

117-96070009-2-2000

$475.00 USD
$475.00 USD
Sale Sold out
Shipping calculated at checkout.
Part Number

Select your machine to get the right part number.

Final sale. This item is not eligible for return. Return and refund policy

Don't see your machine or the part you need? Ask us and we'll track it down.

The Aftermarket Assassins Launch Control Module holds a set RPM at the line on the 2022 to 2026 Polaris RZR Pro R 4 cylinder, building boost on turbo machines or RPM on naturally aspirated ones, for drag racing and other racing starts.

Why it holds up

  • Developed with DynoJet, with AA wiring, programming, tune and tech support
  • AA reports up to double the plenum pressure compared to brake boosting alone, depending on launch RPM, for faster turbo spool and acceleration
  • Launch RPM is programmed by AA and can be changed with a Windows computer and DynoJet C3 software

Fits

  • 2022 to 2026 Polaris RZR Pro R 4 cylinder models only, 2 and 4 seat

In the box

  • DynoJet launch control module, programmed by AA
  • AA wiring harness with launch switch
  • USB cable for adjusting launch RPM

Good to know

  • Requires an AA custom tune (PV3, HP Tuners, or ECU bench flash) to work with this AA wired and tuned module. Read the full description before ordering.
  • 2000 RPM: For AA standard naturally aspirated clutch kits that engage at roughly 2000 RPM.
  • 2500 RPM: For AA turbo clutching that engages around 2500 RPM.
  • Choose the 2 seat or 4 seat version to match your machine.
  • AA highly suggests the AA primary clutch, since the stock clutch may not hold up to launch control, especially above 2000 RPM. Use caution with the OEM clutch.
  • Set launch RPM right at clutch engagement. To find engagement, put the machine in high range on flat ground, press the gas slowly and note the RPM where it starts to move. Repeat a few times for a consistent number.
  • After install, try launch control without holding the brake. The machine should barely want to move. If it lurches, go to a higher stall spring, a fresh clutch spring, or a lower launch RPM.
  • To launch: start the machine and let it idle (the module will not engage above 1500 RPM). Press and hold the launch switch and go full throttle. The machine holds launch RPM. Most riders hold the brake too. Drop the brake and the switch at the same time to go.
  • To change launch RPM: install the DynoJet C3 software on a Windows computer, connect the module with the supplied USB cable, open Configure, then Feature Enables and Inputs Selections, then Launch Control. Change the target RPM and click Send.
View full details